Attenna
This must be extended when you wish to use the remote.
On/Off
This is the main power switch ON applies power
*You must have (4) "AA"
batteries and you will see a RED light (Power)
on.
Power
This light will be on if you have the On/Off
switch set to on and your batteries are good.
Microphone
This is where you speak into the remote and the
Omnibot will repeat what you say.
*You must press the Push
Button on the remote.
Push Button
This is pressed in when you wish have your voice
come though your Omnibot speak into the microphone.
Up (Arm)
This button brings the arm up.
Down (Arm)
This button bring the arm down.
Left (Arm)
This button turns the wrist "CCW" counter clockwise.
Right (Arm)
This button turns the wrist "CW" clockwise.
Up (Directions)
This will send your robot in a forward motion.
Down (Directions)
This will send your robot in a backward motion.
Left (Directions)
This will turn your robot to the left.
Right (Directions)
This will turn your robot to the right.
Finger Open
This opens the fingers in the right hand.
Finger Close
This Closes the fingers in the right hand.
Head Right
This turns the head to the right.
Head Left
This turns the head to the left.
Gear Change
This Changes drive gears from High/Low speed.
Tape Start/Stop
This Starts and Stops the tape when in program mode.
Omnibot Sounds
This plays a little sounds. Play
Sound (62K)
Light On/Off
This turns on the lights in the Eyes.
Back to TOP